How to align dish satellite to increase signal quality for freezing channels

Tips for aligning the satellite dish or satellite dish antenna to improve
signal quality and TV reception. If your satellite dish receiver or DVR
freezes at regular intervals, suffers signal loss and get into the search
mode, the first step is to check the alignment of the KU band dish
antenna or your C-band dish antenna. Strong winds and heavy snow
loads can affect your dish surface and alignment. Here are some tips
to check and adjust the alignment of the satellite dish, which also works
for antenna problems.
Use satellite signal finder meter for sat dish antenna
The best method to verify the alignment of your dish is with a satellite
signal tester. A strength of the measured signal is a simple device that To use a satellite signal meter you have to
use the LNB, short stub antenna cable, key connecting cable and
alignment screws and dish antenna.
The process is simple. Unplug the antenna coaxial cable. Connect the
cable of the plate and dish with the satellite finder meter LNB
IN connection. Connect the receiver cable to the other side of the device.
Turn on the satellite TV system and tune one of the stations that have
difficulties. If your device has a voltage of the display should read 13-18
volts. If the reading of the signal strength is out of range, set the input
to a mid range from the adjusting buttons of the satellite signal finder
meter for sat dish antenna.
Satellite dish antennas are adjusted vertically and horizontally. Loosen
the screws, either vertically or horizontally. Adjust the antenna for
maximum reading on the satellite signal tester and tighten the screws.
Repeat for the other direction. If the mounting plate is not in perfectly
level, it is advisable to repeat the alignment procedure more than once
to get the best fit. If you still have problems with your video, check the
trees or other obstacles blocking the signal. Another cause of irregular
signal may come from a filter fault line that is used by some satellite TV
providers.
Using set-top box inbuilt satellite finder meter
Another method involves the use of measuring an intensity of the
integrated signal in the satellite receiver unit instead of a satellite meter.
Receiver satellite finder can be accessed through the Setup menu or
information. This approach better carried out by one or two assistants to
see on the screen meters and relay information for adaptations.
Configure access to the disk. Get the keys of sufficient size for use in a
dish dowel pins.
Turn on the satellite TV system. Access built-in satellite signal finder
meter for sat dish antenna from the receiver DVR using the configuration
menus or information. Loosen the vertical and horizontal adjustment.
Make sure to obtain the position of the antenna the highest signal level.
Tighten the set screws. Repeat for the other direction. Once again, if the
mounting plate is not perfectly level, it is worth repeating the process
several times in order to ensure the best possible alignment to increase
signal quality.
connects to operate between the LNB and the satellite receiver.

Those who are learner should learn well ooooooooo,thank

A learner could still take many hours to get a simple signal

isaac311 wrote:

A learner could still take many hours to get a simple signal

nah So

Good info.

I just copied powervu keys, nagravision, irdeto2(DSTV) and IPTV from africasatviewers.com But I'm not allowed to share here coz I'll be banned.. any ideas?

please any body know the current feet of focal point of
deep fiber? The size is 20feet lenght and Is 5.5m or 6m any help.