Step 1
Turn on your satellite receiver and your TV. Make sure your TV input selector is set for
the input where you are connected. If you don't see a picture at all, check the cables
between the receiver and the TV. If they are good and you still see no picture at all,
your receiver is bad and you must get it fixed before you can check your dish. If you
see a warning that you have no receive signal, your receiver is OK and you can
continue checking.
Step 2
Look outside at the weather. A heavy thunderstorm between your dish and the satellite
may cause a temporary loss of signal, even though it may not be raining where the dish
is located. If there is a storm, wait until it passes.
Step 3
Look at your satellite dish to see if it may have been knocked out of position by a heavy
wind or a falling object. If the dish seems to be out of position but not broken, call your
satellite company to have it aligned. If it is bent or the feed horn is bent or broken, the
dish is bad. Look from the dish in the direction of the satellite to make sure no trees
have grown into the path, or new houses or buildings have blocked the signal.
Step 4
Look at the cover on the feed horn to see if it is cracked or broken. Water or moisture
inside could damage the LNB. Some have a translucent cover that may show
condensation on the inside that could cause a failure.
Step 5
Check the cable connections at the receiver and the dish. Remove them and look for a
bent or broken center conductor, a damaged connector that doesn't make a ground
connection, or dirt or corrosion that could block a signal. Replace any bad connectors
or call your satellite service company to do it.
Step 6
Check the cable for cuts, breaks or crushing. Follow it for its entire length and look
carefully. A crushed cable could have the center conductor shorted to the shield and
block the signal. If the cables and the receiver are OK, and the dish is properly aligned
and not physically damaged or blocked, you probably have a bad LNB in your dish and
it needs to be replaced.
ur own contribution is needed