Linkstar modem password unlock!

This is for VSAT installers only.

Telnet Password Unlock Procedure



If you have forgotten your password for full Telnet Access, please use the following sequence and procedure to unlock the system.

If your unit is under a lease agreement you may not be authorized to do this, doesn’t apply to owned devices.

Make one of these cables, and open the RCST. Inside there is a serial connector to which you can connect using this cable described below.

Once you connect, you can get direct access, and use the:

"passwd -u root -p newpassword" command to reset it.

Note: change "newpassword" to your desired password.



Linkstar Serial Cable
~~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~

Only the middle 4 pins are used (use a 4 connector phone plug)
Looking at the phone plug with the clip facing away from you.


pin 1 goes to pin 5 on the serial connector
pin 2 goes to pin 2 on the serial connector
pin 3 goes to pin 3 on the serial connector
pin 4 not used
Some loopbacks on the serial connector......
7 and 8 are looped
1 and 4 are looped
6 and 4 are looped

Pls can you pls guide me on how 2 instal dis v-sat?

V-sat installation is almost like satellite tv installation. The difference is that there antenna/dish are different from each other. Also installation and configuration of V-sat is entirely different from that of satellite tv installation. While satellite tv installation is for viewing satellite tv stations V-sat installation is basically for internet service usage. There is no way I could explain to you here but if u can go for trainning u will understand it better and itz a good business!